Products > SMT > Board De-Stacker/Re-Stacker
The ProEx De-stacker module provides automatic bare-board delivery to the screen printing process in SMT assembly lines. Boards are released from the bottom of the stack and delivered to the printer 'on demand' via the SMEMA control interface. The op-loading feature allows new boards to be added to the stack witohout interruption of the delivery cycle. System operational, stack low and unit empty status information is communicated via a two-colour beacon. The De-stacker has a pass-through operating mode for applications where double sided boards are to be produced on a single side line.

The De-stacker is easily adjusted to accommodate boards of differing size and thickness. The nominal stack capacity is 100 boards x 1.6mm thick.

The Re-stacker operates in reverse, receiving and stacking populated PCB's.

Available in Single, Dual lane and vacuum pick-up versions.
Standard Features
Max Stack Height   3160mm (recommended)
Max Board Size 380mm wide x 450mm long
Min Board Size 70mm wide x 120mm long
Board Ride Height 950mm nominal +/- 25mm
Length/Width Ratio Board length should be greater than board width
Fixed Rail Front: travel = left to right
Edge Clearance 4mm for transport purposes
Conveyor Speed 18 m/min
Max Delivery Rate 8 seconds per board
Interface SMEMA
Operating Modes De-stack or pass through
Power 220/240V 1 phase, 50/60Hz, 5A
Air 5 bar clean and dry no lubrication
Non-Standard Designed for your specific application
Click to enlarge

 

Design by Confidence-IT
© CooperRason Limited 2005