Products > SMT > Vision Inspect Link

Via the 'x', 'y' gantry this unit can be configured to house the range of semi-automatic vision appliances as well as LED pick and place modules. Equally adaptable for manual assembly and rework the unit has a multi-control function, which allows for:

  • Buffer/Work/Buffer Control
  • Pass through
  • Selectable inspection stop control, allowing operators to predetermine the number of PCB's that will stop for the inspection, allowing for the balance to 'pass through'. this allows the operator to attend tother duties in the knowledge that the beacon symbol will indicate when the PCB due for inspection is i position
Standard Features
Max Board Size   380mm wide x 450mm long
Min Board Size 70mm wide x 120mm long
Length/Width Ratio Board length should be greater than board width
Fixed Rail Front: travel = left to right
Board Edge Clearance 4mm for transport purposes
Number of Drives 1000 = 2 x drive, 1500 = 3 x drive
Conveyor Speed 18 m/min
Interface SMEMA
Operating Modes Inspection or pass through
Power 220/240V 1 phase, 50/60Hz, 10A
Air 5 bar clean and dry no lubrication
Non-Standard Designed for your specific application
 

 

Design by Confidence-IT
© CooperRason Limited 2005